Where to buy non skid for integrated swim platforms.
#1
Registered
Thread Starter
Join Date: Dec 2008
Location: Detroit, MI/Lake Havasu, AZ
Posts: 729
Likes: 0
Received 1 Like
on
1 Post
Where to buy non skid for integrated swim platforms.
I have a 94 272 and was wondering where I can buy replacement material or exact replacement non skid pieces that are on the swim platform. The 4 non slip sections.
#2
Registered
#3
Registered
Join Date: May 2005
Location: Nashville, Tennessee
Posts: 209
Likes: 0
Received 0 Likes
on
0 Posts
my 2 cents - get the 3m backing pre-installed on it so you dont have to mess with glue. However, take your time removing the old stuff - its a serious pain in the arse but well worth it in the long run. get a pack of razor blades ready to scrape it bit by bit in order to get all the nasty off the platform.
#4
Registered
I agree, get the 3m backing pre-installed on it so you dont have to mess with glue. Once I removed the old stuff I used Goof Off to get the nasty glue residue off.
Last edited by baja pete; 03-30-2011 at 02:53 PM.
#6
Registered
Join Date: May 2005
Location: Nashville, Tennessee
Posts: 209
Likes: 0
Received 0 Likes
on
0 Posts
i just picked out a color that i thought matched the boat the best...then ordered a sheet with the 3m backing...made a template and cut it out with an exacto blade
#7
Registered
I contacted them and had them send me samples of 3-4 colors that I thought would look good and different patterns, then I chose what I liked best. Made a template and cut it out with a razor knife.
Make sure your pattern is a thick/stiff material so you do not get any flex when tracing it out.
Make sure your pattern is a thick/stiff material so you do not get any flex when tracing it out.
#8
Registered
Join Date: Apr 2006
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
My Donzi 35 ZR was a total hazzard. After two cases of nearly big injuries, I went with No Skidding (www.noskidding.com) Lots of colors and styles to pick from, and excellent customer service.
#9
Registered
Join Date: Dec 2010
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Just did our 272 with hydroturf, used the purple w cut grooves. Turned out really nice. Peeled the old stuff off and used adhesive remover on the goo. Will try to get a pic posted.
Last edited by Coupe5oh; 04-01-2011 at 06:57 AM.