Arizona speed & marine??? - Page 7

CAB · 03-02-2010, 04:02 PM

Does anyone have anything good to say about their products? I am not talking about them doing any programing of any kind. I am talking if I buy their system and have someone else do the tuning.

Cookin · 03-02-2010, 07:22 PM

I am using their Ramjet intake for BBC and their high flow billet throttle body[1030 cfm].Also bought their larger billet fuel rails.Someone else did the programming on the dyno with MEFI BURN system.Works great and made good power.Hardware was fine.He did have a cam made for me that was not what I asked forand wasn't billet,just hardened.My engine builder had comp make a cam.The engine made 606hp/660tq.

CAB · 03-02-2010, 10:10 PM

Quote:

Originally Posted by Cookin

I am using their Ramjet intake for BBC and their high flow billet throttle body[1030 cfm].Also bought their larger billet fuel rails.Someone else did the programming on the dyno with MEFI BURN system.Works great and made good power.Hardware was fine.He did have a cam made for me that was not what I asked forand wasn't billet,just hardened.My engine builder had comp make a cam.The engine made 606hp/660tq.

This is the same route I was going to take. Glad to here it is ok.

Strip Poker 388 · 03-23-2010, 03:48 PM

http://www.youtube.com/watch?v=8Nmrs5ieVec

..........

heatwave3 · 03-26-2010, 08:05 PM

bump

Strip Poker 388 · 03-26-2010, 11:26 PM

Quote:

Originally Posted by heatwave3

bump

dump

ViciousOne · 03-30-2010, 12:05 AM

I bought a pair of AZSM efi packages for a pair of 502's for one of my 31' cats equipment was good , calibration was TERRIBLE ! Tyler recalibrated the ecu's and all was fine.
If you have issue's Crockett Marine engine is the place to go,
good honest guy !

Jassman · 04-10-2010, 07:12 AM

and if you are close to LA or MS Mark at Precision is the other guy to go to..

http://www.pmefi.com/

saltlick · 04-15-2010, 11:11 PM

Quote:

Originally Posted by Strip Poker 388

dump

AZ Speed's assembly area looks like someone's unkept garage! I am convinced that those clowns couldn't have known my MEFI unit from another. They probably just pulled mine out of a heap of junk on Monday morning, attempted to program it (for like the 4th time), and ship it while being proud that their useless service just landed them another several hundo!!

dhaferkorn · 05-21-2010, 11:27 PM

I have just had my ECM reprogrammed by ASM, along with flow testing the injectors. They also picked the roller cam I should use. I just became aware of this site and quite frankly, you guys have me scared to death. I'm in Wisconsin, where should I go that is local?