Playboy Cig Video
#1
Registered
Thread Starter
Playboy Cig Video
A buddy of mine shot a quick video of us last weekend runing from Marina Del Rey to Hutington Beach. Last part of the video is behind the Long Beach breakwall - hit 92mph on GPS with about 900lbs of fuel on board...I think she still has a few mph's left but I was breakin in a new motor so I didn't wanna push it too hard for too long
[YOUTUBE]http://www.youtube.com/watch?v=zPPqKUTN_Us
[/YOUTUBE]
[YOUTUBE]http://www.youtube.com/watch?v=zPPqKUTN_Us
[/YOUTUBE]
Last edited by LZH; 09-22-2010 at 08:32 PM.
#3
Registered
Thread Starter
#5
Registered
Thread Starter
Fixed
Also some good shots of the new windshield - man, what a difference that thing makes. I can now cruise at 55mph and have a conversation...Although the fit and finish leaves a bit to be desired for $1400 - I have to modify the ferring to cover up the brackets and screws...
Also some good shots of the new windshield - man, what a difference that thing makes. I can now cruise at 55mph and have a conversation...Although the fit and finish leaves a bit to be desired for $1400 - I have to modify the ferring to cover up the brackets and screws...
#6
VIP Member
VIP Member
Sweeet video. What HP on the engines??
I just looked into my crystal ball...........I see some new outdrives in your future!!
I just looked into my crystal ball...........I see some new outdrives in your future!!
__________________
Happily retired and living in Heavens waiting room.
Happily retired and living in Heavens waiting room.
#7
Registered
Thread Starter
Ha!! Motors after being rebuilt better and much stronger are putting out ~580hp in front of XR uppers and IMCO shorty lowers. Takes a bit longer getting outta the hole with the shorties but it makes up for it on the top end I've had this drive setup for 2 years with no issue. Actually just opened them up last week and replaced a clutch in one and bearing in the other - everything else looked perfect...these drives were on Steve's OSO Galdiator - rebuilt by Dollar and they did a fantastic job on them - obviously
#9
Registered
Thread Starter
Check out this thread; there are a few already posted
http://www.offshoreonly.com/forums/c...labor-day.html
http://www.offshoreonly.com/forums/c...labor-day.html