Depth Tranxducer
#1
Charter Member #139 /Moderator/Platinum Member
Charter Member
Thread Starter
Join Date: Nov 2000
Location: McHenry IL /Duck Key FL
Posts: 2,201
Likes: 0
Received 0 Likes
on
0 Posts
Depth Tranxducer
I have upgraded my dash to all new Livorsi/Gaffrig Guages
I have not put the new depth sounder transducer in yet the existing on Huminbird is glassed into the hull has any on replaced this or did you just cut the wires and put in a new one?
I have not put the new depth sounder transducer in yet the existing on Huminbird is glassed into the hull has any on replaced this or did you just cut the wires and put in a new one?
#3
Charter Member #139 /Moderator/Platinum Member
Charter Member
Thread Starter
Join Date: Nov 2000
Location: McHenry IL /Duck Key FL
Posts: 2,201
Likes: 0
Received 0 Likes
on
0 Posts
I will get picture tonight
The original was a square face huminbird and I am pretty sure the Gaffrig is a round face Huminbird the original tranducer pliug was round and new one was square so being the Pollock that I am I fit the round pulg in a square hole but it dint work.
Gafrig or Humonbird did not hasve sny sdspters so I msy hsve swsped polarity oops.
The original was a square face huminbird and I am pretty sure the Gaffrig is a round face Huminbird the original tranducer pliug was round and new one was square so being the Pollock that I am I fit the round pulg in a square hole but it dint work.
Gafrig or Humonbird did not hasve sny sdspters so I msy hsve swsped polarity oops.
#8
VIP Member
VIP Member
on my tiger it is right in front of the starbord motor, similar to where klaws is. I have a new one but I'm not going to rout out the floor, I'm just going to epoxy it right to the hull a little further back under the motor.
#10
VIP Member
VIP Member