Cafe Restore
#11
Registered
Thread Starter
Join Date: Feb 2013
Location: Antioch Il
Posts: 159
Likes: 0
Received 0 Likes
on
0 Posts
Sorry for late response I have been out of town until today, do you still need this answered?
#12
Gold Member
Gold Member
Yes - but it is no rush. If you have the information that would be great. I haven't even pulled the cover off yet, and as we all know here mysterious things can happen over the winter and for all I know this could be VERY low priority when I pull the cover off.
#14
Registered
quick question, the 2 holes on the deck right where it goes flat in the walk way... where do those drain holes go to? or what are they for? mine has them too. and looking great! you dont want to get rid of the trailer do you?
#15
Registered
they go to the deck hatch recess area. If you open the hatch, you can see them on the backside. In theory, the water drains from the deck to the hatch recess, & runs off to the side of the hull. mine always pools up in the hatch area though where its even more difficult to clean out.
#16
Registered
they go to the deck hatch recess area. If you open the hatch, you can see them on the backside. In theory, the water drains from the deck to the hatch recess, & runs off to the side of the hull. mine always pools up in the hatch area though where its even more difficult to clean out.
#17
Registered
Thread Starter
Join Date: Feb 2013
Location: Antioch Il
Posts: 159
Likes: 0
Received 0 Likes
on
0 Posts
some pics finally
Sorry for the delay, life has been busy. Fiberglass work is done, boat sides look excellent had a lot of chips repaired, I had to have some of the chimes repaired as they were chipped, the black was repaired in back both sides[ATTACH=CONFIG]522034[/ATTACH][ATTACH=CONFIG]522035[/ATTACH][ATTACH=CONFIG]522036[/ATTACH][ATTACH=CONFIG]522037[/ATTACH][ATTACH=CONFIG]522038[/ATTACH][ATTACH=CONFIG]522039[/ATTACH], had the strips removed off of top deck below engine hatch. I had the new vents installed, I do like them and it gives the boat much better lines and they look great, but they just are not quit the quality I was looking for but they will do for this summer. Maybe I am being to picky.
Goes to upholstery guy 4-21 to get cover made and interior finished up. Then to engine guy 4-28, to get rebuilt engine reinstalled, thennnnn it goes to detailer to get top deck final finishing done and new strips applied. Then back to me to finish Stereo install!!
In the meantime I am dropping off swim platform to get it powder coated black this week.
Should be all set to go for Blarney New year May 16th!!! I hope
Last edited by Yamaha24; 04-15-2014 at 12:29 PM.
#18
Registered
Thread Starter
Join Date: Feb 2013
Location: Antioch Il
Posts: 159
Likes: 0
Received 0 Likes
on
0 Posts
Well finally this is done.... Starboard was 23' Port was 26'. Again sorry took so long.
[ATTACH=CONFIG]522040[/ATTACH]