Mercury thunderbolts IV ignition with a V6 module
#2
Gold Member
Gold Member
My Cam Card says:
Intake Valve Lift - .64627
Exhaust Valve Lift - .62974
Roller Cams. Weiand 177 blowers
I am running that V6 module. I am not a very knowledgeable person, but several people on here recommended I run it. I worked with Bob M for all my stuff and I "believe" I recall him saying he'd try it as well. In a conversation with Nickerson on my carbs they casually mentioned that with my set-up they would use that V6 module. All of those factors was enough validation for me to spend the 250 bucks and try it.
I am not running ragged edge timing though - I believe I set them up at 32*
Intake Valve Lift - .64627
Exhaust Valve Lift - .62974
Roller Cams. Weiand 177 blowers
I am running that V6 module. I am not a very knowledgeable person, but several people on here recommended I run it. I worked with Bob M for all my stuff and I "believe" I recall him saying he'd try it as well. In a conversation with Nickerson on my carbs they casually mentioned that with my set-up they would use that V6 module. All of those factors was enough validation for me to spend the 250 bucks and try it.
I am not running ragged edge timing though - I believe I set them up at 32*
#4