Please help with my 1989 320 EFI Mercruiser
#1
Registered
Thread Starter
Please help with my 1989 320 EFI Mercruiser
Very frustrated. It appears that the throttle position sensor, Merc. PN 14882A2 went bad. They are no longer available from Merc. Has anyone found a replacement from a secondary source? Any ideas? Maybe someone replaced theirs with an intake and carb set up and could sell me some of the old parts? Thanks.
#2
Registered
Very frustrated. It appears that the throttle position sensor, Merc. PN 14882A2 went bad. They are no longer available from Merc. Has anyone found a replacement from a secondary source? Any ideas? Maybe someone replaced theirs with an intake and carb set up and could sell me some of the old parts? Thanks.
#3
Registered
iTrader: (1)
There is a # printed on it, but I cannot see it from the below picture from Merc's catalog.
Can you get the # off the TPS and we can try to go from there ?
Can you get the # off the TPS and we can try to go from there ?
#4
Registered
Thread Starter
#5
Registered
Thread Starter
Couldn't make out that number on the bad one. Will pull the good one off the other engine later and see if I can read it.
Can't believe I may have to switch to carbs over 1 stinking sensor.
#7
Registered
Looks very Lucasish,
http://www.epartsland.com/products/8...a-215sa-73305a
Are you able to sweep the sensor to find the resistance range?
Jeff
http://www.epartsland.com/products/8...a-215sa-73305a
Are you able to sweep the sensor to find the resistance range?
Jeff
#8
Registered
Very frustrated. It appears that the throttle position sensor, Merc. PN 14882A2 went bad. They are no longer available from Merc. Has anyone found a replacement from a secondary source? Any ideas? Maybe someone replaced theirs with an intake and carb set up and could sell me some of the old parts? Thanks.
#9
Registered
Thread Starter
Looks very Lucasish,
http://www.epartsland.com/products/8...a-215sa-73305a
Are you able to sweep the sensor to find the resistance range?
Jeff
http://www.epartsland.com/products/8...a-215sa-73305a
Are you able to sweep the sensor to find the resistance range?
Jeff
Thanks for the help. There is one of those on eBay now also. The end that goes into the throttle shaft looks different though. I don't know how to sweep the sensor but think I can figure out how to throw this crap fuel injection in the dumpster LOL
#10
Registered
Thread Starter