22ft. Donzi help
01-31-2013, 07:09 AM
#1
Registered
Thread Starter
Join Date: Nov 2003
Location: Fairhaven Ma
Posts: 833
Likes: 0
Received 0 Likes
on
0 Posts
22ft. Donzi help
Customer just picked up a 22, think its a 88-91 year, used to have Arneson drive so we had the transom rebuilt. We are getting ready to cut hole for Bravo, what is the proper "x" dem. or measurement, from bottom of V to center line of tool/crankshaft. Any help would be great, im sure there lots of opions.
01-31-2013, 10:03 AM
#2
Registered
Customer just picked up a 22, think its a 88-91 year, used to have Arneson drive so we had the transom rebuilt. We are getting ready to cut hole for Bravo, what is the proper "x" dem. or measurement, from bottom of V to center line of tool/crankshaft. Any help would be great, im sure there lots of opions.
They varied over the years. head to donzi.net for more help specific to this. If it were me I'd go with the '87 X. it's a bit over an inch higher than the regular X and the boat runs much better like that. Donzi did the same thing on the Shelby and picked up speed.
