Bravo one driveshaft
09-01-2009, 10:53 AM
#1
Registered
Thread Starter
Join Date: Dec 2008
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Bravo one driveshaft
I have 2001 bravo ones that have driveshafts with taped holes instead of threaded studs. Is this normal or something someone customized. The bolts used are stainless with no markings.
09-01-2009, 07:21 PM
#2
Charter Member
The older drive shafts were threaded, as in my '99 B1's ,OM serial #'s.
The newer shafts went to a tapped hole. Also are larger in dia. Sure those bolts are SS? I'd be surprised if they were. The shaft I just installed came with a reg. grade 5 bolt, non S/S. Don't know when the change over occured to the tapped end and larger dia shafts, but appearantly around 2000.??
I drilled and tapped my old shaft for a spare, as the threaded end got stripped.
The newer shafts went to a tapped hole. Also are larger in dia. Sure those bolts are SS? I'd be surprised if they were. The shaft I just installed came with a reg. grade 5 bolt, non S/S. Don't know when the change over occured to the tapped end and larger dia shafts, but appearantly around 2000.??
I drilled and tapped my old shaft for a spare, as the threaded end got stripped.
__________________
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
Last edited by US1 Fountain; 09-01-2009 at 07:24 PM.
