jr marine gimbal kit
07-11-2011, 08:47 PM
#2
Registered
Platinum Member
07-13-2011, 09:12 AM
#5
Registered
I've done it too, its a great kit and much easier way than the merc plugs!
I also put sealant around the bolt holes and engraved the Baja logo into mine before installing it. It looked pretty damn trick!
I also put sealant around the bolt holes and engraved the Baja logo into mine before installing it. It looked pretty damn trick!
07-18-2011, 07:27 PM
#8
Registered
Thread Starter
Join Date: Jul 2005
Location: gasport ny
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
ok thanks. bought one. i still think it looks a little hackish but its better than pulling the motor and transom plate off. i cut mine today and i would not have been able to get to the top nut even with the motor out. i still would have had to pull the plate off
07-18-2011, 09:40 PM
#9
Charter Member
That cover plate kinda make me question it's reliabilty to seal.
Rather have a leaky seal than a leaky cover plate. A buddies boat has 2 leaking seal. I'm talking him into either pulling the motors or use the Merc kit. Too much of a risk for a boat that lives in the water.
Rather have a leaky seal than a leaky cover plate. A buddies boat has 2 leaking seal. I'm talking him into either pulling the motors or use the Merc kit. Too much of a risk for a boat that lives in the water.
__________________
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
