Bottom Blueprinting

Allicat38 · 01-02-2010, 04:02 PM

Has anyone done this and what kind of costs are involved. Who is best to do the work. Just wondering what it would take to have it done to a 30ft. Any perfromance gains handling and speed has anyone seen from this type of work. I think it woild be ideal to have the tweeked just right and run low power. I live in the northeast

Allicat38 · 01-02-2010, 04:03 PM

My boat with 4 ft level is not perectly flat. there is 2 curves in, about 1/16 inch in the 4 ft secton 1 ft up from the vee. One spot is a little worse, looks like some kind of touch up.
Anyone in pa Nj do this kind of work or is this minor. Iwill run it for now but in the future i may really try to dial in my boat. Both sides seem to be the same. Manufactures should fine tune there bottoms out of the mold, it would be pretty simple at that point.

twistedvelocity · 01-02-2010, 10:48 PM

What boat are you working with and what year?

LAKESIDE RESTORATIONS · 01-03-2010, 10:25 AM

Alli,

I answered your question in the other section.

Jamie / Lakeside

Quote:

We do that kind of work. I am located in NE PA.. The price depends on the amount of work involved. Price would really depend on how much bottom work is required on yours.

I am doing a blue print on a boat currently in our shop. If you want to look into it further with me, feel free to give me a call. Anyplace in Jersey is a pretty easy drive to us..

Jamie / Lakeside Restorations 570-639-2628

.