New to Fountains
#1
Registered
Thread Starter
Join Date: Aug 2010
Location: Atlanta, GA
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
New to Fountains
Hi All!
Recently purchased a 2002 27 Fever. It is very different than the cruisers I have had in the past.
Wanted to say hello!
Was wondering if anyone knows where the Water Pressure & Oil Temp sensors are on the motor? Those are the only things not working.
Recently purchased a 2002 27 Fever. It is very different than the cruisers I have had in the past.
Wanted to say hello!
Was wondering if anyone knows where the Water Pressure & Oil Temp sensors are on the motor? Those are the only things not working.
#5
Registered
Join Date: Nov 2005
Location: monrtose.mi
Posts: 219
Likes: 0
Received 0 Likes
on
0 Posts
great looking boat. and welcome. your water psi is mecanical and it should be on the port side of the motor just under the freeze plugs more to the rear. oil tenp depends on the motor.
#8
Registered
Thread Starter
Join Date: Aug 2010
Location: Atlanta, GA
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the welcome!
Thank you for the info. I am going to go look at that this afternoon. Added new latches for the cuddy door as well. Nice to get the mold out of the boat.
Correct it is a 502 MPI motor.
Thanks for the welcome!
Correct it is a 502 MPI motor.
Thanks for the welcome!
#9
Registered
Join Date: Nov 2009
Location: Slidell LA
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
Very nice! Welcome to the club. The tube for your water pressure sensor is probably clogged with sand/silt at the engine. That was my problem, it was so blocked up I had to cut off over a foot of it and replace. Works great now.