Have to raise port motor 1 inch
#21
Registered
Thread Starter
It's 1/2 at the gimble. 1/4 of bottom gone from blueprinting. Probly just have to raise back of motor 1/2. leave front mount alone. Not too thrilled about a new set of holes about 5/8 or so from old ones. Exhaust is a long story. Getting ready to test it here in a little bit.
#23
Registered
Join Date: Nov 2006
Location: Corona, CA
Posts: 755
Likes: 0
Received 0 Likes
on
0 Posts
That boat looked bad ass running yesterday, I don't think I would touch it.
If you REALLY wanted to have it done, I would go talk to the Camire's at Lavey Craft in Corona.
If you REALLY wanted to have it done, I would go talk to the Camire's at Lavey Craft in Corona.
#24
Registered
Thread Starter