Help, can you tell me what went wrong?
Ok so i was cruisin along on sunday in the Nordic. I was going about 40mph. I decided to hit the throttle and speed up, when I did there was a sudden loud beep. The boat slowly came to a stop and since the throttle was still engaged the motor just reved up. So I put the boat in nuetral and opened the engine compartment. Smoke was coming from the belt/pulley area and it smelled like a burnt serpentine belt. I check to see if my boat still goes into gear, which it does. It will go into gear but as soon as I give it some gas it does the same thing again. boat will go no where,rpms will jump up,motor will rev up and the smoke will start up again. I dont think its a spun prop.What do you guys think? Bearings?coupler? Impellar pump? One last thing, its a 496 with a bravo, boat has 55hrs on it and was just serviced. Oil change and drive was checked for alignment. thanks
|
Re: Help, can you tell me what went wrong?
Sounds like you spun a coupler, if you had fried an impeller it would have overheated and you would still be able to move.
Caleb |
Re: Help, can you tell me what went wrong?
Originally Posted by timewarp
Sounds like you spun a coupler, if you had fried an impeller it would have overheated and you would still be able to move.
Caleb Or the drive seazed [low oil?]and locked up the drive and spun the hub. just guessing :drink: Rob |
Re: Help, can you tell me what went wrong?
Coupler!
|
Re: Help, can you tell me what went wrong?
Coupler.
|
Re: Help, can you tell me what went wrong?
Coupler
|
Re: Help, can you tell me what went wrong?
I was still able to idle my boat back on to the trailer.
|
Re: Help, can you tell me what went wrong?
My guess-Coupler
Similar thing happened to me on my Nova years back outside the Golden Gate. Motor mount collapsed, caused engine/drive misalignment and spun coupler-towed in at 125.00 per hr by Sea Tow @ 5mph for 6 hours...ouch...Wife still reminds me on the expense not including yanking motor. Good luck hope it works out 4u |
Re: Help, can you tell me what went wrong?
Originally Posted by wantacat
I was still able to idle my boat back on to the trailer.
|
Re: Help, can you tell me what went wrong?
Originally Posted by wantacat
I was still able to idle my boat back on to the trailer.
Drive coupler is spun. Dean |
All times are GMT -5. The time now is 09:45 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.