blackhawk drives
does anyone know about blackhawk drives? i have one with the prop shaft wiggles slightley and the two props rub so slightley together. any suggestions?
|
Re: blackhawk drives
Get it apart and checked. Sounds like you have a bearing between the shafts gone. Mine are perfectly tight, no lateral play at all.
|
Re: blackhawk drives
Originally Posted by Airpacker
Get it apart and checked. Sounds like you have a bearing between the shafts gone. Mine are perfectly tight, no lateral play at all.
|
Re: blackhawk drives
Sounds like a bad bearing to me. Get ready to spend some dough too. You will proably end up rebuilding the entire drive before you are done. Post back on the board if you run into any problems getting parts.
|
Re: blackhawk drives
I don't know what you mean by "wiggles" but my blackhawk had slight play between the inner and outer propshaft. If I remember correctly there is supposed to be a few thousandths of an inch there.
Did you check your thrust washers? |
Re: blackhawk drives
Originally Posted by Cord
Sounds like a bad bearing to me. Get ready to spend some dough too. You will proably end up rebuilding the entire drive before you are done. Post back on the board if you run into any problems getting parts.
|
Re: blackhawk drives
[QUOTE=noboat]I don't know what you mean by "wiggles" but my blackhawk had slight play between the inner and outer propshaft. If I remember correctly there is supposed to be a few thousandths of an inch there.
Did you check your thrust washers?[/QUOTE yes the thrust washers are ok |
Re: blackhawk drives
Also dont forget the washer between the props.
|
All times are GMT -5. The time now is 03:06 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.