couple weeks ago on LOTO
 

couple weeks ago around 4:00pm on a saturday afternoon rough water broke under water bracing on dock and then frt arms on hoist.

later

Re: couple weeks ago on LOTO
 

:eek: :eek: Why couldn't it have been the sea-doo?

Re: couple weeks ago on LOTO
 

my neighbor two houses down had his cruiser do the same thing... the neighbor in between us had to call him in down in arizona and tell him his 40' cruiser was laying on its side on the dock... :eek: rough water is nothing to mess with, make sure you have the best dock/lift you can get...

Re: couple weeks ago on LOTO
 

they all break eventually.

Re: couple weeks ago on LOTO
 

I have seen this quite a few times here they said there are rough water lifts that a lot of people don't want to spend the extra $$$ for but by the # of boats I have seen like this I know I will be getting one when I get my boat. Like Sean H I usually see the one side give out though and the boat laying on the side.

Re: couple weeks ago on LOTO
 

thats why i have the 6 arm 12k lift for the 7k boat.... and its bolted to the heaviest/baddest concrete dock i could afford.. only have had minor issues and i am pretty much right off the channel at the 18....

Re: couple weeks ago on LOTO
 

Thats going to be my problem I am at the busiest part of the lake with little break wall so no matter what I get I can expect a lot of maint. :(

Re: couple weeks ago on LOTO
 

they all claim they have rough water lifts, then ask about there warranty when there sitting on the main channel. been there done that !

later

Re: couple weeks ago on LOTO
 

Sean H
do you have one of the concrete docks or concrete decking. if its a concrete dock how is it holding up? the design is relativly new and have been wondering how there doing in the rough.

later

Re: couple weeks ago on LOTO
 

concrete decking with the mini j-joist or whatever they are called that rough water docks uses..... that seems to work fine, its where my ramp meets the dock that i think i will have my biggest issue.. it takes a ton of strain... we already switched it out to a 1" steel rod for a pivot pin...