drives...yes or no question
okis...i just need a simple straight forward response for this question...will raising the x dimension lower the bow lift?thank you
|
Re: drives...yes or no question
maybe :D :D :D :D
If the X is real deep, then probably not. |
Re: drives...yes or no question
you will get some better answers in the tech section... thats where the smart guys hang....
|
Re: drives...yes or no question
That's what the trim switch is for.
|
Re: drives...yes or no question
Well, yes and no.
|
Re: drives...yes or no question
Originally Posted by stecz20
you will get some better answers in the tech section... thats where the smart guys hang....
|
Re: drives...yes or no question
well if the drives are too low...
|
Re: drives...yes or no question
Originally Posted by stecz20
you will get some better answers in the tech section... thats where the smart guys hang....
There is no..Yes or No...It depends. deeper,spinning in should carry the bow more...Maybe Now throw props into the equation also..... |
Re: drives...yes or no question
All other things being equal raising the x will cause the bow to drop. If the drive is higher it exerts less leverage and drops the bow. Some boats get extensions at the same time to bring some of the leverage back. But if you just move the prop up (like an outboard with a jack plate) it will drop the bow at the same trim position.
|
Re: drives...yes or no question
Raising the drive height from stock Bravo X on your style hull will lower your bow, and if she porpoises now even a little bit ,she will be like flippers older brother with less X and also net way slower speeds.
|
All times are GMT -5. The time now is 02:35 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.