Does anyone make a #6 drive Prop lock?
 

called Trick today and sternlock, could only find bravo locks, does anyone know a source for these, thanks wiggler

Re: Does anyone make a #6 drive Prop lock?
 

try a prop case.............mark.....

Re: Does anyone make a #6 drive Prop lock?
 

this could work

Re: Does anyone make a #6 drive Prop lock?
 

Wiggler The McGard lock that is for the Mercury Blackhawk drives are the same shaft, size, thread etc. the will work! I have used them on #6s before with no problems!

Re: Does anyone make a #6 drive Prop lock?
 

thanks big daddy, case is nice but dont want to take off 3every time boat goes on lift, jim

Re: Does anyone make a #6 drive Prop lock?
 

Those cases are exactly what I use. It takes a minute or two to pull them off every time, but I would rather do that than have them stolen. I think our marina is fairly secure and nearly everybody else leaves their props on, but my luck is not good enough to take that chance!

Re: Does anyone make a #6 drive Prop lock?
 

Thanks for that info. I posted my reply above before I read your post. I would consider leaving them on with the locks in place. I guess that they can still be stolen, but maybe if they are locked the thief would go over to another boat and steal their props instead.

Re: Does anyone make a #6 drive Prop lock?
 

who sells that lock in united states, should I just call them, thank jim

Re: Does anyone make a #6 drive Prop lock?
 

I bought mine (2) sets through either Overtons or Ski Un,limited . Overtons 1-800-334-6541 part #25765 1"x14 thread it willsay they fit Bravo3 , Blackhawk , 69.99 each