Exhaust down tubes. Whos using them?
06-24-2006, 07:55 AM
#31
Platinum Member
Platinum Member
Re: Exhaust down tubes. Whos using them?
ttt
06-24-2006, 09:37 AM
#32
Re: Exhaust down tubes. Whos using them?
I just tried a pair last night on my Outerlimits w/twin 1000's and Staggered # 6's . The boat was quiet as hell at idle, when i started put the power to it , the boat felt VERY restricted for a few seconds then came into and took off, got back to the dock and one of the center turn-down pipes had blown off. Maybe the pipes were picking up some spray and restricting it ?? The stagged drives are tight, the pipes barly fit. Need to research it more...we're considering cutting them a little shorter, any ideas?
06-24-2006, 10:09 PM
#33
Re: Exhaust down tubes. Whos using them?
They are Gibson turn downs. In their info they say they must be at least 4-5 inches in the water, i measured mine they are 9-10 inches in. I'm guessing water may be getting deflected into them by bouncing off the ITS rams. Cutting 4 inches off them will raise them high enough out of the spray, and still be long enough to be in the water to muffle properly at idle...i hope 
06-25-2006, 09:46 AM
#34
Registered
Join Date: Nov 2003
Location: Monroe, WI
Posts: 179
Likes: 0
Received 0 Likes
on
0 Posts
Re: Exhaust down tubes. Whos using them?
Originally Posted by cosmic12
HOW DO THE 4 INCH WORK ON v BOTTOMS? anybody usem?
I put them on my V last year, I have not been pulled over for noise once, it use to be a weekly thing.
