Re: New Engines: 557 or 572
Originally Posted by mikes280
the 1077 is the mls gasket i have had good luck with them, are they leaking water or are you blowing them and if so where
|
Re: New Engines: 557 or 572
Originally Posted by Strip Poker 388
I don't like a sq or over sq motors.the thrust angle and the big slug your trying to sling..
Remember back when the Nascar guys were destroking there motors making more power. Also why do you think Sterling is running that cube, they have people spending $$$.I bet the experimented on a few costumers :rolleyes: I would think they figured it by now whats the best combo, again there looking at max hp in a race application and usually have a higher RPM peek hp .I would think The bigger the ci the lower the RPM. CI cal http://www.itpapulling.com/ci_calc.html http://www.ajdesigner.com/phpengine/...lacement_b.php piston speed http://www.csgnetwork.com/pistonspeedcalc.html http://www.thedirtforum.com/pistoncalc.htm rod ratio http://www.mustang123.com/calculator...Calculator.asp What would make you think that they are interested in low maintance intervals and overall motor longevity??????? Otto |
Re: New Engines: 557 or 572
Originally Posted by Tapa11
Are the solid rollers really worth the trouble?
|
Re: New Engines: 557 or 572
Originally Posted by 36spectre
Due to harmonics....always build a square engine...they are happier and
they will last significantly longer |
Re: New Engines: 557 or 572
Originally Posted by Panther
Can someone confirm or deny but I understand the 572' has a less than optimum rod-to-stroke ratio.
|
Re: New Engines: 557 or 572
Originally Posted by ratman
572 4.5 X 4.5
|
Re: New Engines: 557 or 572
1 Attachment(s)
Dean what CI are these, I forgot what you told me.
Thanks Bro excellent job! |
Re: New Engines: 557 or 572
Originally Posted by mrhorsepower1
This is one way to achieve 572 cu.in. ( the most common)
|
Re: New Engines: 557 or 572
Originally Posted by GPM
which one would hold up better 572 or 598 both with the same rod length?
|
Re: New Engines: 557 or 572
Originally Posted by customryder
Dean what CI are these, I forgot what you told me.
Thanks Bro excellent job! |
All times are GMT -5. The time now is 04:47 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.