Imco Minus 2 Trade
#1
Registered
Thread Starter
Join Date: Dec 2004
Location: IN & KY
Posts: 210
Likes: 0
Received 0 Likes
on
0 Posts
Imco Minus 2 Trade
I purchased -2 lowers for XR drives. They were a little too agrressive on height. Instead of adding spacers, does anyone have -1 cases or complete lowers they would be willing to trade. Mine are as new with about 10hrs of use. They were purchased as cases and now have my XR prop shaft installed. I can disassemble for case trade or complete trade. Just don't like the idea of spacers.
#3
Registered
Thread Starter
Join Date: Dec 2004
Location: IN & KY
Posts: 210
Likes: 0
Received 0 Likes
on
0 Posts
Re: Imco Minus 2 Trade
Thanks for the reply, I still have my stardard XR lower cases with dual water pick-ups if that's what you were refering to. Instead of taking advice on purchasing -1s, I went with -2s and was a little too high. I thought why not try, I could always lower them. Now I find myself not wanting to use spacers because of appearance.
#4
Registered
Re: Imco Minus 2 Trade
Originally Posted by brianshelton
Thanks for the reply, I still have my stardard XR lower cases with dual water pick-ups if that's what you were refering to. Instead of taking advice on purchasing -1s, I went with -2s and was a little too high. I thought why not try, I could always lower them. Now I find myself not wanting to use spacers because of appearance.
#7
Registered
Thread Starter
Join Date: Dec 2004
Location: IN & KY
Posts: 210
Likes: 0
Received 0 Likes
on
0 Posts
Re: Imco Minus 2 Trade
I'm running them on a 2001-42' Fountain. I've only tried them with the stock Bravo props that were on the boat (serial numbers match original invoice of boat). I don't think I want to start throwing money at different props and such. The boat ran good with stock lowers with the 575s, just thought I'd try to gain little. I boat with someone that had good luck with only going 1" higher than stock on a similar age Fountain. Thought I'd try 2" and slips too much with stock props, I think?