Re: Turbine Cat Drive Instillation Help Needed!!!
Here is the web site.
http://www.n2speedturbineboats.com/ The boat I seen is the in lower rite corner |
Re: Turbine Cat Drive Instillation Help Needed!!!
Originally Posted by Rik
(Post 1981698)
I think that video is with Peter Heldin, Mike D'Anniballe and Pat Patel in the boat.
|
Re: Turbine Cat Drive Instillation Help Needed!!!
Call John Cosker @ Mystic Powerboats, he has designed and rigged quite a few turbine powered cats and v-bottoms. His office # is 386-736-2247.
Good luck, Dean |
Re: Turbine Cat Drive Instillation Help Needed!!!
The boat is an aluminum boat made by the same company that fabricated the cougars, I will give them a call see if they can help.
Engine HP is 1600@100% |
Re: Turbine Cat Drive Instillation Help Needed!!!
2 Attachment(s)
Rik
I have temporally set up the drive on the back of the boat to show you the stern tube angle and prop height how does this look? I spoke to turbine marine they said a good stating point would be a prop hub height of 2.5" above the inside of the sponsons with a sterntube angle down of around 3-6 degrees. |
Re: Turbine Cat Drive Instillation Help Needed!!!
2 Attachment(s)
Engine Turbomeca Turmo 1560hp
Output shaft speed 6000rpm Dropbox ratio 1-1 |
Re: Turbine Cat Drive Instillation Help Needed!!!
Turbines are a lot softer on drives than big diesels or supercharged petrol's. If you check the chart they advise you call for turbine applications.
I have run Arneson drives on all my boats over the years many of which engine torque has far exceeded Arneson recommendation, to date I have never had one fail they are a bulletproof drive system simple but super strong. Jason |
Re: Turbine Cat Drive Instillation Help Needed!!!
Originally Posted by Ron P
(Post 1981646)
JetSet rocks!
Watch video. |
Re: Turbine Cat Drive Instillation Help Needed!!!
I only smelled him a few times this summer.
I hope the new 46 JetSet is ready for this summer.:) |
Re: Turbine Cat Drive Instillation Help Needed!!!
Ron is it that bad?
Any idea what size fuel tanks he has on board that thing must be burning at least 200gph at full tilt. |
All times are GMT -5. The time now is 10:59 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.