Work coming along on the Condo
#502
Registered
Join Date: Nov 2003
Location: 1 Flu Ovr KuKos Nest-WI
Posts: 9,950
Likes: 0
Received 0 Likes
on
0 Posts
Downtown, I am not afraid to run my engines like others. They put the engine on warm it up, make two pulls and say it's finished. All of our marine engines get a minimum of 2-3 hours of actual run time. Warm up, break in , and testing. Cylinder heads are re-torqued , valve lash run a few times ( when applicable) , compression and leak down test performed after testing, ect. The Bad Boys are ready to rock when they go in the vessel. Of all the pairs or triples we have built, none have been no futher apart than 8 horsepower.
#503
Geronimo36
Gold Member
Just got back from my boat though....installed the sub and speakers..it's LOUD!
#504
Banned
#505
VIP Member
VIP Member
You better not forget about me!!!!!!!!! See ya soon!
#506
Registered
Thread Starter
Join Date: Jul 2005
Location: Colts Neck,NJ
Posts: 2,149
Likes: 0
Received 0 Likes
on
0 Posts
It was supposed to be but we got held up with gettin the generator running. It was easier for Tommy to get his fat azz in there without the engine in the way. Its all good now. Everything works. You can't rush perfection.
#507
Registered
Join Date: Feb 2005
Location: oceanport nj
Posts: 1,626
Likes: 0
Received 0 Likes
on
0 Posts
Glad to hear you're finally getting there!!!
#509
Banned
#510
Registered
Join Date: Feb 2005
Location: oceanport nj
Posts: 1,626
Likes: 0
Received 0 Likes
on
0 Posts
Frank did all the work. I supplied some wire and advice. With all the room in the cockpit (lack of room) I pointed from the dock a lot. He did a great job and I'd hire him if he wasn't so expensive! He's all set with the new mtx thunder marine setup. Sounds nice and a awesome improvement over the 1 pair of 6.5" standard horizon speakers that were in there before.