few more..............

-Installed Sea Strainers
-Powdercoated treadplate on bulkhead
-Freshened Shortblocks
-Removed Iron GM Heads and Installed Brodix Aluminum with new cams
-Switched from 28 4 blade to 29P5X
-75mph to 82mph

Your Frige won't like the wind!!! :drink:

How can a Canadian afford to buy all the stuff??? Do you have somewhere where you get all that shipped in the US and then a good friend of yours gets it to you to install in your boat ????
Or What? :D:D :evilb:





Boy am I glad all those freaking boxes are out of my office!!! :D

1990 Shadow cat with twin 300PM
1-Replaced some soft wood on floor and re glass
2-Replaced a trim cable
3-Water pumps on lowers
4-Rebuilt one lower (Gears and bearings)
5-Put in a new indicator for tunnel tab
6-Built in a micro switch to tunnel tab trim indicator to limit downward travel
7-Put on Jackplates
8-Re rigged and rerouted all hoses and cables to the motors
9-Put rigging tube and bezels to make it look good
10-And this is what I am most proud of,Designed and Built my Tunnel Tab

Pic of Tunnel Tab and Jackplate

Just remembered
11-Replaced poppet valves
12-Installed new billet vents

Just writing a check for a outdrive rebuild and new gimbal ,and Bblades doing the prop....:drink:

Looks like the heads and cam really woke them up

What Brodix heads did you use?

Mark:drink:

Put the boat away tuned up ,one rebuilt drive , washed and waxed. Sat around and gained a few pounds.Where is the sun?