Who Has Or Sell Sea Strainer Cap With Reg Hose Fitting?
 

Just want to simplify the task when I want to run engines on hoses... does it exist or I have to invent this by myself?

Tell me if you already have this!!!

Thanks.

It's out there. Look in the back of some larger boat mags. They woek great.

Call Fred at Trick Marine

Yes, great idea, I have gill strainers with plastic lid 1/2" thick.
Why not thread for a garden hose barb connection for engine flush.
I could use that forsure times two.

bringing back this tread. still don't have a fresh water flush system for TRS, AND, Trick marine does not exist anymore, so... any suggestion where I can find those?

M&M will sell you some stainers that has a port for a flush or you could pipe them in yourself.

I would think it would be hard to drill and tap it with out it cracking, I replaced mine from over tighten and cracked,

On my Hustler it has a plastic/PVC T fitting on the inlet hose close to the transom. goes to a valve to select from port and star. I can take a pick if ya need one, should be cheap, you could even leave off the valve and just cap the end and hook a water hose when ya want to flush.


post 104 http://www.offshoreonly.com/forums/s...t=92301&page=3

Not to try & sidetrack the thread but what did you have to pay for the new lid ? & what brand strainer was it ? I have a M.M. on the way that will be needing a new lid... I was told that it is the same as the Gil but not sure... I have emailed a couple people trying to get a price including M.M. & no luck yet getting a response. Thanks , Scott

I want to say 40-50 on the gil, my CP perf for the blower has allready cracked, I need to get a new one for it. I dont think the mm is the same as gil,its closer to the CP/hardin