Offshoreonly.com - Bravo Transom Template

Page 3 of 3

Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Boating Discussion (https://www.offshoreonly.com/forums/general-boating-discussion-51/)

- - Bravo Transom Template (https://www.offshoreonly.com/forums/general-boating-discussion/185591-bravo-transom-template.html)

Young Performance

05-08-2008 12:02 AM

Scott,
I missed your thread asking for the jig. I have one and you are welcome to it. If I would have known, you could have got it when you picked up your block. Sorry I didn't see it sooner. Anytime you need something like that, let me know.
Eddie

littledcsrodshop

05-08-2008 12:25 AM

Hey Eddie ,
I appreciate the offer & yeah that would have worked out good but oh well , I guess a man can never have too many tools...
I hope all is well with you & your family along everything else in the western end of the state.... The motor finally came togather nicely & is pretty much ready to go in the hole... Now if I could just get the time to finish getting the boat ready for it.

O.C.Barry

05-12-2008 10:35 AM

Paper template

Quote:

Originally Posted by txriverrat2001 (Post 2544798)

I'm pretty sure I still have the paper template if you need.

Let me know and I'll dig it up and mail it to you - an no charge!! LOL!!

I'm getting ready to cut my transom for Bravo's. I can use the paper template if you are still willing to part with it. I did the same thing when I cut for the 3A SSM's on the last boat, traced a paper template on Luan, made the cuts then resined the template so it wouldn't warp or splinter.

If you can send it, I appreciate it:

Barry DeBald
9105 Simms Ave.
Balto, ND 21234

Thanks, Barry

All times are GMT -5. The time now is 11:14 AM.

Page 3 of 3

Show 40 post(s) from this thread on one page