Wodster69

Can you hook both power steering pumps up?
On my boat the starbort motor steering pump is hooked up to the steering. But the port motor the steering pump is looped back to itself.
The other day when i lost the starbort motor and had to limp it back with the port the steering was a mother with no power.
So i was wondering if could have them both hooked up just in case. Anything special needed to do this?

Thanks
David

C_Spray

iTrader: (2)

Yes, you can. Run both of the high-pressure output lines to a tee, and install check valves in both lines, with the direction of flow towards the tee. This will prevent back-feeding the pump on the engine that is not running. You will also have to tee the supply line from the reservoir to the pumps, but no check valves are required there, as it is feed line. If you want to get fancy, you can install coolers on each engine as well, but this will require two more tees; one on the low-pressure return from the helm, and one in the return line to the reservoir. Again, no check valves would be needed for the cooler lines.

copiercat

teague has the crossover kits, i think their around $150.00.
merc used to sell them but discontinued a few years ago

monstaaa

imco has the proper valve assembly as does c.p performance