600SCI owners
#52
Chris
Gold Member
600sci Stage II = Reprogramed PCM + Innercooler water re-route + smaller pulley.
I just picked up between 9 and 10 mph with this upgrade!
My boat was consistantly doing between 80 and 82 mph, and now it is doing between 90 and 92 mph.
The picture below was my first pass after the Stage II upgrade.
I went faster (91.6 mph) with another prop, but was so excited, I forgot to take a picture of it.
Thankyou Dustin !
Chris
I just picked up between 9 and 10 mph with this upgrade!
My boat was consistantly doing between 80 and 82 mph, and now it is doing between 90 and 92 mph.
The picture below was my first pass after the Stage II upgrade.
I went faster (91.6 mph) with another prop, but was so excited, I forgot to take a picture of it.
Thankyou Dustin !
Chris
Last edited by CB-BLR; 02-28-2009 at 08:33 PM.
#55
Chris
Gold Member
Your boat is stunning!
I have not done the cam change yet. My motor only has about 40 hours on it, and just went out of warranty in febuary.
I was planning on doing the cam at the first rebuild, in a couple of years.
Did you put in the 700 cams?
What did your mechanic charge for the cam swap.. per engine?
I only have one.
Chris
I have not done the cam change yet. My motor only has about 40 hours on it, and just went out of warranty in febuary.
I was planning on doing the cam at the first rebuild, in a couple of years.
Did you put in the 700 cams?
What did your mechanic charge for the cam swap.. per engine?
I only have one.
Chris
Last edited by CB-BLR; 02-28-2009 at 08:57 PM.
#59
Registered
VIP Member
VIP Member
Sorry Dreamer
Had a big poker run/race down here in the Islands right after the boat show and my Doug Wright wasn't quite ready at the time.......got a hell of a deal so I couldn't pass it up.
Had a big poker run/race down here in the Islands right after the boat show and my Doug Wright wasn't quite ready at the time.......got a hell of a deal so I couldn't pass it up.
#60
Registered
VIP Member
VIP Member
Thanks CB
My cams were actually 500EFI cams which are a little more aggressive than the 700EFI cams......a few friends and I installed the kits over a weekend. We ended up taking the top end off the engines while keeping them in the boat.....not that bad as long as you have someone who knows what they're doing and follow all of the torque specs, etc.
My cams were actually 500EFI cams which are a little more aggressive than the 700EFI cams......a few friends and I installed the kits over a weekend. We ended up taking the top end off the engines while keeping them in the boat.....not that bad as long as you have someone who knows what they're doing and follow all of the torque specs, etc.