How much too tall are they? I had a tall set, but I needed them for my staggered engines. 1 riser fit just under some fiberglass on the side of the engine compartment. I brought that riser to a friend with a welding shop. He cut it down just over 2" and TIG welded it back together. The bung is now 1" from the flange. I polished all of the welds and you can't tell it from any of the other risers.
|
So it sounds like it's not a catastrophic issue. At my closest guess, I'd say that the risers are 1-2 inches too high on the outboard side only. The inboard risers look like they will clear the hatch without modification.
Can anyone recommend a good welding shop in or around Charlotte NC that could do the work? |
Originally Posted by damdonzi
(Post 2660898)
These are what I have. Let me know if this is what you are looking for.
|
I do. Sitting in my garage as you read this.
|
Now this is impressive, 13 years later and not only got a reply but the risers are still available, made my night 😂🤘
|
Originally Posted by damdonzi
(Post 4798477)
I do. Sitting in my garage as you read this.
|
All times are GMT -5. The time now is 11:06 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.