What Happens When Drive Breaks Off?
#11
Registered
Like Dreamer said if the tie bar comes off, bellows rip and down she goes. Fortunately ( or unfortunately LOL ) the tie bar held the drive on and had sort of a happy ending. LOL No hull damage. Just drives and ego. Happened on Georgian Bay's 30,000 Islands back in 2002. Many of the 30,000 Islands lurk just below the surface.
No problems since. I learned another lesson.
Bob
No problems since. I learned another lesson.
Bob
WOW!!!! Took all 3 drives out. Damn you really are fortunate that all 3 bellows held. Glad to hear no one was hurt.
Darrell.
#12
I would think side load would be the cause of the race stuff,
but hitting something hard enought to brake housing and ring would have to shock the sh!t out of the transom,stress cracks
but hitting something hard enought to brake housing and ring would have to shock the sh!t out of the transom,stress cracks
__________________
.
The Only Time You Have To Much Ammo Is When Your Swimming Or On Fire.
.
The Only Time You Have To Much Ammo Is When Your Swimming Or On Fire.
#13
VIP Member
VIP Member
Join Date: Sep 2005
Location: Marco Island, FL; Waterloo, ON, CAN
Posts: 5,736
Received 121 Likes
on
21 Posts
Bob
#15
Strip, no doubt it would be a shock to the transom but there were no visible cracks or I would have had them fixed. It was an insurance deal anyway so they would have picked up the tab. I was back on the water the next weekend after DoubleR snapped on 3 new drives.
Bob
Bob
__________________
.
The Only Time You Have To Much Ammo Is When Your Swimming Or On Fire.
.
The Only Time You Have To Much Ammo Is When Your Swimming Or On Fire.
#16
Registered
Join Date: May 2004
Location: Okanagan Falls BC. Canada
Posts: 596
Likes: 0
Received 1 Like
on
1 Post
its the bellhousing [ hat ] that's the weakest link. As it can be seen in the picture the broken area isn't much to carry all that weight hanging on so something got to give. I have Bravo 1X drives with standard gimbal ring that stayed intact. The right trim cylinder rod got bent and got replaced.I also replaced the upper housing [ insurance was involved so I didn't bother welding up a piece ] I was crusing around 40 mph only and got stopped dead in my track striking that log. Boat didn't spun at all. Higher speed and it could have been a bit different , lol.
Small piece [ guide that holds the plastic shims] broke away .
Last edited by spectras only; 01-24-2009 at 07:45 PM.