Originally Posted by Strip Poker 388
(Post 2799292)
Hustler wants $500.00 for the ladder and 2 years ago it was $250,I snoozed:rolleyes: We tried getting the screws/bolts out of the Ladder tonight,it started cracking the fiberglass, it must have the nut style, nut inserts made into the swim platform when the boat was made,and must of been installed with no anti seize:( its not accessible at all. Any suggestions?
might mess with it in the spring, might have to get the cuting saw out :D: |
If an auto finish (dupont, ppg, sikkens) is used what is the tolerence to being in the water. Would being in the water for a weekend or a week cause problems?
|
Originally Posted by augie58
(Post 2799729)
If an auto finish (dupont, ppg, sikkens) is used what is the tolerence to being in the water. Would being in the water for a weekend or a week cause problems?
|
1 Attachment(s)
Originally Posted by daredevil
(Post 2799732)
Drill them out with a small drillbit and then they usualy come lose !!!!!
Im guessing this or a nut is made into the fiberglass |
Paint it!!!
|
Paint is much easier to clean than gelcoat, however I have seen paint bubble if the boat is left in the water for a long weekend.
|
Originally Posted by Edward R. Cozzi
(Post 2800409)
Paint is much easier to clean than gelcoat, however I have seen paint bubble if the boat is left in the water for a long weekend.
Ed I Hadnt had any bubbleing with the factory paint on the sides.maybe it was preped right? |
Strip,
Just painted my transom.......only regrets is that the paint shop did not take out my exhaust tips because they were afraid of stripping the screws....wish they would have anyway as I would have installed new tips.....only so close they could get around the tips for sanding:mad: |
All times are GMT -5. The time now is 06:42 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.