Go Back   Offshoreonly.com > General Discussion > General Boating Discussion


OSO Sponsor
NorTech
OSO Sponsor

Advertiser

Advertiser


Reply
 
 
 
 
Thread Tools
Old 05-31-2009, 06:49 PM   #1
Registered
 
Fountain38SC's Avatar
 
Join Date: Jan 2002
Location: Cincinnati, Oh
Posts: 1,145
38 Fountain SC
$50.00 to the 1st person that can diagonsis this!!!!

Boat runs great, lost 1/2 the electric on the way in. No drive or trim tabs, no cabin power, nothing on the driver or cabin panel works. All was good until I trimmed in the snot offshore. Then the above quit. Had to limp back with the drives & trim at about 1/2 trim. Rear hatches won't go up. Checked the breakers I know of but no luck. This has to be something stupid but IDK what it is. Boat charges and runs like a champ. Boat is a 38 Fountain SC. Help!! & yes, if u get it right I'll send u the $'s.

yes, diagnos is spelled wrong - can't change it
Fountain38SC is offline   Reply With Quote
Old 05-31-2009, 07:01 PM   #2
Registered
 
Fountain38SC's Avatar
 
Join Date: Jan 2002
Location: Cincinnati, Oh
Posts: 1,145
38 Fountain SC
Soon as I can open the hatches, I'll take a look but there is sone power to the dash that makes me question the 12v wire. I have power to some parts of the dash but not all. I can run the blige pumps, blower ect., but that's about it.
Fountain38SC is offline   Reply With Quote
Sponsored Links
Old 05-31-2009, 07:25 PM   #3
Platinum Member
Platinum Member
 
Join Date: Aug 2004
Location: Raymond, Maine
Posts: 141
Check the ground post on the back of one of the motors. If the nut is loose or the connection between the terminal or wire is bad, it could cause this. You might want to post this in the tech section as well.
E Colby is offline   Reply With Quote
Old 05-31-2009, 08:01 PM   #4
OSO Moderator
Charter Member
 
SpeedGirl's Avatar
 
Join Date: Sep 2000
Location: Mamaroneck, NY
Posts: 8,166
Avanti & Formula 280SS
maybe a bad battery switch??
__________________
You are judged by the company you keep!
SpeedGirl is offline   Reply With Quote
Old 05-31-2009, 08:35 PM   #5
Registered
 
Join Date: May 2009
Location: Dunmore,PA
Posts: 79
not sure how the boat is wired, but battery switch? or grounds for certain items. the motors still running would indicate that the grounds on the motors seem to be fine. what you said worked still is important items that are usually separate from extra electronics.
Timeless61 is offline   Reply With Quote
Old 05-31-2009, 08:48 PM   #6
Registered
 
Fountain38SC's Avatar
 
Join Date: Jan 2002
Location: Cincinnati, Oh
Posts: 1,145
38 Fountain SC
The bliges, nav, anchor lights, ect on the dash still work. The 2 blidge lights & the nav lights are lit on the dash but aren't running. I threw a charger on the boat for the nite. G/f was willing to slide between the hatches & hook the charger up. In the AM, I'm going to disconnect the hatches so I can check the connectors & spend several hours pondering the issue over a few beers.

IDK wtf went south but this is a good 1,
Fountain38SC is offline   Reply With Quote
Old 05-31-2009, 09:13 PM   #7
Registered
 
Join Date: May 2009
Location: Dunmore,PA
Posts: 79
just eliminate one thing at a time, don't try to check things all at once
Timeless61 is offline   Reply With Quote
Old 05-31-2009, 09:42 PM   #8
Cold as a Blue Dog
Platinum Member
 
Airpacker's Avatar
 
Join Date: Aug 2001
Location: Aurora Ontario
Posts: 3,910
little cat...BIG MOTOR
check the big plug on the harness between the motor harness and the boat harness. Pull it apart and plug it back together
__________________
Happiness is a Boat and a nice bit of Tail
Airpacker is offline   Reply With Quote
Old 05-31-2009, 10:30 PM   #9
Ship Faced II
Platinum Member
 
SmurfOnABoat's Avatar
 
Join Date: Dec 2008
Location: Detroit, MI/San Tan Valley, AZ
Posts: 701
Baja 272 w/ its blue and whistles.
Not trying to be a smartass, but did you check all your fuses for the switch panel?
SmurfOnABoat is offline   Reply With Quote
Old 05-31-2009, 11:30 PM   #10
Registered
 
Join Date: Oct 2000
Location: Spring Lake, MI
Posts: 328
Advantage
Next to your trim pump is a 20 amp fuse (in the factory merc harness). I bet that is shot, and for some odd reason they pulled power from that to power a portion of the panel.

If the motors run and the guages have power then the 9 pin plug is fine. The power from that is only used for guages, ignition, and power to the trim/tab switches, Assuming it is wired corectly.
Todd Hartigh is offline   Reply With Quote
 
 
 
 
 
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are Off



All times are GMT -5. The time now is 03:55 AM.


Copyright 2011 OffShoreOnly. All rights reserved.

Search Engine Optimization by vBSEO 3.2.0