Well, if you could absorb the power instead of letting it slip, you would be faster. Can't argue with that, well maybe you can.

Your boat runs fast, (like it should with that power) almost as fast at that larger V hull that your engine builder had.:eek:


I've got customers with single engine Talon's and a lot less hp than yours going mid 120's and no swapping ends. :grinser010:

26Redline,

I have wondered about the prop issue on the RPM cats. They seem to get cavitation burns on the middle of the blades which eventually causes blade/prop failure.. ie they throw a blade.

I thought this might be just on Steves boat/outdrive combination, but sounds like it is a boat issue.

Your thoughts?

Chris

Well, if you could absorb the power instead of letting it slip, you would be faster. Can't argue with that, well maybe you can.

Your boat runs fast, (like it should with that power) almost as fast at that larger V hull that your engine builder had.:eek:


I've got customers with single engine Talon's and a lot less hp than yours going mid 120's and no swapping ends. :grinser010:[/QUOTE]

Well lets see...my engine builder's engine was a 572, he had it turning 7400pluss RPM's, and was running 110 octain gas. I am turning 6000-6400rpm's on 93 octain with a 540, and FYI the engine that is in my boat was in Gary's boat for 33hrs, with the 200AX Whipple on it and the boat would only run 102mph, straight from his boat to mine I ran 118-120 with a 34 labbed prop until the supercharged was changed to the 305AX 5.0L Blower:gfight:

Chris,

The prop issue on Steves boat is from the bullet design on the lower, I have not had any problem from the MMW drive doing that to any props, what I am saying about the labbed props, is that with the torque that I am putting through the leading edge of the props start to break after just a few test hrs, I took a custom 34 that Steve had Hering do in Jacksonville, I brought it home from Jacksonville ran it on 2 outings approx. 6 hrs, sent it back to Steve, and ran his boat 1 time and the blades started breaking (sorry again Steve):kiss:

Well lets see...my engine builder's engine was a 572, he had it turning 7400pluss RPM's, and was running 110 octain gas. I am turning 6000-6400rpm's on 93 octain with a 540, and FYI the engine that is in my boat was in Gary's boat for 33hrs, with the 200AX Whipple on it and the boat would only run 102mph, straight from his boat to mine I ran 118-120 with a 34 labbed prop until the supercharged was changed to the 305AX 5.0L Blower:gfight:[/QUOTE]

So you are saying the V hull went faster than your?:eek:

Have you ever tried the P5-x's ?

My boat likes them better than the Herings or Labbed Bravo's.

I have the P5-x's labbed by Hering (right up the street from me)

Chris

So you are saying the V hull went faster than your?:eek:[/QUOTE]


I think that Gary's Howard 28 has done a best of 133mph.

I think this cat will beat that.

Chris

Im thinking you should just that damn thing and buy and new one :party-smiley-004: Then there would be some used RPM's on the market for some of us po' folk :lolhit:

There is a great deal on a used RPM in the Classifieds right now.

I have driven this boat, and it is just pure fun!

Chris

So you are saying the V hull went faster than your?:eek:[/QUOTE]

Your not very bright, are you...:signs043: