Who's running a #6 in a single engine application
#21
Registered
I think the arneson will be worth the work. I am sure Rik will give you all the help and support you need.
Try a little more homework and call him he is the master and will point you in the direction you want to go... If once you spoke to him and he says too hard to make work... The Weisman would be my second choice!
Good luck
Try a little more homework and call him he is the master and will point you in the direction you want to go... If once you spoke to him and he says too hard to make work... The Weisman would be my second choice!
Good luck
#23
Registered
Thread Starter
Join Date: Jun 2007
Location: Denham Springs La.
Posts: 606
Likes: 0
Received 0 Likes
on
0 Posts
#24
Registered
Join Date: May 2004
Location: Okanagan Falls BC. Canada
Posts: 596
Likes: 0
Received 1 Like
on
1 Post
26Redline , send a PM to member "kanedog" on performanceboats.com/ . He has an 26 Eliminator Daytona with #6 hanging off the stern.
In this picture he didn't have one , but after breaking a few drives he went for the 6.
In this picture he didn't have one , but after breaking a few drives he went for the 6.
#25
Registered
Thread Starter
Join Date: Jun 2007
Location: Denham Springs La.
Posts: 606
Likes: 0
Received 0 Likes
on
0 Posts
The paddle is a nice touch for more HP that drive can handle I love it...I started to buy a motorguied "Im Lazy"
#26
Registered
Join Date: Jul 2005
Location: Tulsa, OK
Posts: 1,729
Likes: 0
Received 0 Likes
on
0 Posts
I'd think the #6 would a no brainer. As Sea-Dated said, Masher has been running one on his 32 Activator for quite some time. He doesn't pull his punches either. It has been well tested for a single engine application. I haven't ever heard him say that he was down due to drive issues. I was thinking one would look good hanging off of my 24 Superboat too!
#28
Bling Bling
Platinum Member
Join Date: Nov 2003
Location: Santa Barbara
Posts: 347
Likes: 0
Received 0 Likes
on
0 Posts
Do the #6, that boat will run like a raped Ape. I Talked to Steve about building a #6 boat a while back and I whoosed out. If not a 6 do Arneson RIKs route. Either way that boat is gonna run very well.
#30
Registered