To do list b4 season
1. Get boat from storage
2. Install new stereo system (head unit, amps, 4 speakers, sub. wired remote) 3. Drain and refill drive (Boat has sat for 2 years so Ill change it even tough it hasnt been used) 4. Install new exaust tips and exhaust plumbing(from manifolds back) 5. Mount Skeg Guard to hide that nasty ding. 6. Install 2nd battery/switch. 7. Pre-lube motor (again, it has sat for 2 years). Pull plugs and lube each cylinder. De-wiinterize. Adjust trailer brakes-replace if needed. Put on four new wheels/tires I just ordered. Redo bunks. New graphics at some point this spring. How bout the rest of you? |
Long List
Boat from storage
pull props-done clean out left over things from last year since I could not then-done Get Prostocker scoops back from factory-waiting :( Pull drives send drives out to clean up skeg repair check u-joints and shafts Check gimbal bearing Pull port motor to replace coupler Pull starboard motor to pull starter Pull starter off port motor and send both out for refreshing order who knows what parts :( have decision made by this time on what stereo componets to order. install amp, sub and speakers wet sand and polish top deck should have found a 380 Keikafer center tab by now. install new tab after patching old mounting holes. install new rub rail insert. clean cockpit carpet clean entire inside after installing amp, subs and speakers. parts should be here by this time, I hope :) reinstall port and starboard motors align install drives install original props that have been 'done up' land test everything on the hose write apoligies to neighbors for motor and stereo disturbances :) Water test reconditioned props Order knew Hydromotive props :) Testing testing testing Get on the road to LOTO Hope I did not forget anything opps I did order GPS speedo and install |
Well here's my list :
Remove cocoon (shrink wrap) = done Take boat to marina have motors pulled off= done Plug holes and finish off transom=done Make transom plate for motors to hang from=done Paint transom plate=drying as I type Get all new hardware for hanging motors= done Have new seals put in one motor( Lower unit) Have new trim pump motor installed on other motor Compound and polish hull Take boat back to marina to have them hang motors Change out fuel filters Get new plugs for motors Install new bearings on Trailer=done Charge batteries Test it all out Have a couple of cold ones Then I'll be ready for the Summer:D :D :D |
First, I have to re-assemble my motor. After that I'll worry about the "little" stuff like paint.....drive oil....etc.... :cool:
|
I am with foul. If I am in by July I will by psyched!!!! :( :( :( :(
|
1) finish assembling new XR upper
2) finish putting nosecone one (thanks Mike) 3) assemble drive and install 4) oops , have to replace gimbal bearing for larger XR u-joints . 5) change valve springs 6) lash valves 7) change oil 8) check valve lash now that engine is warm 9) install new Gaffrig gauges (thanks wally) 10)reinstall stereo (did a hack job first time),add a set of 6 x 9 's 11) Mount k-planes (thanks again wally) 12) install new race fairing 13) check trailer brakes 14) detail interior and exterior of boat 15) detail trailer WHEW ! now it's ready to use !!! |
All times are GMT -5. The time now is 04:23 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.