Dyno vid-straight down the barrel
#1
Registered
Thread Starter
Dyno vid-straight down the barrel
Here's a dyno vid of a 502 Mag MPI with a 2.3 L Whipple, looking right down the throttle body. I ditched the stock Mag throttle body in favor of a 2000 cfm piece. The stocker is a major restriction for making power with these. It also got a cam change, extrude honed intake, conversion rocker studs and roller rockers, Mefi 4 ecm and harness, and a set of Cometic head gaskets. Everything else is bone stock. It was actually running out of ignition right at 5000 rpm because of the stock 10 yr old plug wires and coil I wish I would have had more time to get a set of wires and a coil on it because with the cam and the extrude honing it should have pulled to about 54-5500 rpm. I really think it would have made close to 800 hp. It made a best of 754 hp and 841 ft lbs of torque, missing it's azz off over 5K rpm. It should be a BUNCH of fun in a 25' Baja. Enjoy. Thanks for looking.
By the way.....check out the 2-80# injectors just under the throttle body. At lower rpms you can see them pulsing, but as it reaches 5000 rpm, they almost look like they are on all the time since they are pulsing so fast.
Here are the links to the vids:
http://www.youtube.com/watch?v=wubuyaEcTBc
http://www.youtube.com/watch?v=bZcBU7vclYU
Eddie
By the way.....check out the 2-80# injectors just under the throttle body. At lower rpms you can see them pulsing, but as it reaches 5000 rpm, they almost look like they are on all the time since they are pulsing so fast.
Here are the links to the vids:
http://www.youtube.com/watch?v=wubuyaEcTBc
http://www.youtube.com/watch?v=bZcBU7vclYU
Eddie
Last edited by Young Performance; 08-12-2010 at 08:07 PM.
#4
KiloKat
VIP Member
Join Date: Jun 2001
Location: Edwardsville, IL
Posts: 971
Likes: 0
Received 0 Likes
on
0 Posts
#6
Registered
Join Date: Apr 2005
Location: Northeast Pa
Posts: 477
Likes: 0
Received 0 Likes
on
0 Posts
#7
Platinum Member
Platinum Member
iTrader: (1)
#10
Registered
Thread Starter