Looking for a new motor for my Nordic heat
Will I sold my Whipple 496 ho and looking for some more hp. After going back a forth I think that I'm more looking into a n/a big ci motor that will make around 750hp on 92 pump gas. I'm up to see what is out there as I do want to keep my xr in one piece as long as I can. Looking to build new but would love to find something used for less money. i would realy love it to be efi. I have lighting headers but need everything else. WHATS OUT THERE????? I have a hand full of money burning a hole in it. Need ti spend.
|
i would say i nice 572ci 700 to750 hp motor would be a good choice to help keep the xr alive or you could go with a 598 or 600 ci :) same hp rating but more TQ,
if you take it easy getting on plane and keep of the stick when getting air either motor's will be fine on a xr for a while . i had an xr on a 2005 28 pantera with a 600 ci 750 hp motor and the drive lived for over 80 hour's until i sold the boat and from what i herd the new owner put another 50 hour's on it before a rebuild , so it all depend's on how you are going to drive . iv herd of guy's blowing xr drive's with 525's but they do whole shot's from a dead stop :( lot of nice looking motor's in the oso classified's mike |
just a few motor's
http://www.offshoreonly.com/classifi...o35937-en.html this guy also build a 572 and a 598 but check out this 632 :) http://www.offshoreonly.com/classifi...o30538-en.html http://www.offshoreonly.com/classifi...o37424-en.html http://www.offshoreonly.com/classifi...o37048-en.html |
keep it going, I need a good deal and have cash in hand!!!
|
607 ci n/a
Crower /Crower /Diamond /Brodix /Jesel >>>>> 803 hp 767 ftlb 92 octane /carb to pan fresh with Dyno sheet two avail Jim |
Look up Superbabi under Superboat fourm, he is selling his boat and took the engine out, it is 800EFI Built by Ron Potter
bad azz looking engine. |
I got one last night thanks for all the info bbc 572
|
Check with OSO member NordicFlame, he's got tons of experience with Heat engines and might be able to hook you up. Good guy too.
|
You might wanna look into pricing or buying a GM crate 572ci motor online.....can get a very good starter setup at a reasonable price...then kinda go from there to setup to your wants and needs for HP and reliability... good luck!
|
All times are GMT -5. The time now is 06:34 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.