anyone have a dyno that will handle high hp?
02-05-2011, 10:37 AM
#1
Registered
Thread Starter
anyone have a dyno that will handle high hp?
we have a new engine that we can only tune the low hp stuff up to around 1800, and we need to find someone with a dyno that will handle alot more to tune it when we turn the boost up.
anyone have a dyno with dual water brakes?
anyone have anything with a very large water supply so we can do constant load testing for long time? minuites? hours? with out boiling the water?
Tyson
anyone have a dyno with dual water brakes?
anyone have anything with a very large water supply so we can do constant load testing for long time? minuites? hours? with out boiling the water?
Tyson
Platinum Member
02-05-2011, 02:24 PM
#3
Registered
02-05-2011, 05:07 PM
#4
Registered
iTrader: (1)
Join Date: Apr 2002
Location: Lake of the ozarks
Posts: 1,233
Likes: 0
Received 0 Likes
on
0 Posts
We have 1000 gallons in reserve and 2000 hp + brake dual rotor Supply pump too big it had to be regulated down.
Come and take a look or call, plus we are not that far.
Jim
573 346 5250
www.ozarkspeedandmarine.com
Come and take a look or call, plus we are not that far.
Jim
573 346 5250
www.ozarkspeedandmarine.com
02-05-2011, 05:53 PM
#6
Registered
iTrader: (1)
Join Date: Apr 2002
Location: Lake of the ozarks
Posts: 1,233
Likes: 0
Received 0 Likes
on
0 Posts
Also we can run our full wet cmi's with 8 egt's and o2 sensor 
Have adapter to run dual cooler rear mount starter as well.
Thanks
Jim W.
Have adapter to run dual cooler rear mount starter as well.
Thanks
Jim W.
Last edited by thumper038; 02-05-2011 at 05:56 PM.
02-05-2011, 08:13 PM
#8
Mark at Precision runs 2 diesel truck engine brakes. I'm sure he can handle the power.
__________________
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
02-05-2011, 08:32 PM
#9
Registered
Join Date: Mar 2010
Location: Salisbury, NC
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
Running for minutes or hours is the deal killer with most dynos. That is a lot of water and cooling capacity! It would be difficult to keep the absorber water cool, let alone the engine coolant. I'm not saying it can't be done, its just a big under taking.
