Originally Posted by fastscarab22
(Post 3358813)
Here we go, dont put a whale tail on it , it will keep the bow lift down and loose top end. A four blade will come plain a lot faster than a 3 blade . I have a scarab 22 with 600 hp or so and i run a labbed 30 bravo 1. i think maybe a 22 pitch would be great on the boat and come on plain real fast. I f you want put some electric tabs 8x12 on it and that would help when you have a full boat. . I think your rev limiter is set at 4850 so forget about going to 5000
|
Originally Posted by wjb21ndtown
(Post 3358767)
Don't get a whale tale. Those things are useless IMO. It may be helpful to drop down a pitch size in prop. You shouldn't lose much speed, and you may gain something if you can get your RPMs up to 5k. What motor do you have in that thing?
Another option may be to send the props to BBlades to have them labbed. It sounds like you may not be too far off in your prop selection. Some fine tuning may do wonders for your boat/setup. |
|
I have a nice used set of boat levelers ready to go...PM for details
|
Originally Posted by northernoffshore
(Post 3358860)
|
The boat came with a 3 blade mirage 23 pitch, the ride better with a 4
|
Originally Posted by fastscarab22
(Post 3358902)
The boat came with a 3 blade mirage 23 pitch, the ride better with a 4
|
If your current prop is a 23" and that can run 58 @ 4800, then you should still be able to run 52-54 @ 4800 with a 21". That is assuming your drive gear is a 1.62 and 8-12% slip. A Revolution 4 would be a great allrounder for sure. IF your drive ratio is 1.47 it's a bit different. Then your current slip is 18%, and that is high for that boat, and there might be an issue. By issue I mean the prop you are running now is just plane wrong for the boat, and you should start from scratch and go baseline testing.
Good luck. |
Originally Posted by A.O. Razor
(Post 3358946)
If your current prop is a 23" and that can run 58 @ 4800, then you should still be able to run 52-54 @ 4800 with a 21". That is assuming your drive gear is a 1.62 and 8-12% slip. A Revolution 4 would be a great allrounder for sure. IF your drive ratio is 1.47 it's a bit different. Then your current slip is 18%, and that is high for that boat, and there might be an issue. By issue I mean the prop you are running now is just plane wrong for the boat, and you should start from scratch and go baseline testing.
Good luck. |
If you want. pm and i will give you my cell and we can talk scott
|
All times are GMT -5. The time now is 06:15 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.