Complete and Utter Failure!
 

I have a new found repect for boat biulders. I just "pulled" my first "mold" from teh plug i made for my new dash. Well I gues si must have messed up eth gelcoat mixture somehow becasue it was still uncured in a few spots. And i dont; think i put enough release on becasue that thing was on there. It wound up coming off in several pieces with a crow bar. At this poitn i think i might just remove all eth release and shoot gelcote over the plug and just use that. It is gonna weigh a ton though....

All you boat biulders. I commend you. Its a hell of alot harder to make **** out of fiberglass than it sounds. (not to mention the skill to design it)

Glad to see I'm not the only one up at this ungodly hour, getting ready to wrench on the boat. Trying to get up to LK. Geoge this weekend. Puder are you working on that now, or what?