Catmando

Interesting gauge layout. I rode in a triple 40 and the owner said it weighed almost 13k with fuel. I think you'll be lucky to see 50mph.

Jassman

I thought it had trip 350's..like about every 40 Ive seen.. My bad.....

Catmando

It should have had trip 480s unless that engine was not available when the boat was built. The 440 was though.

I think the owner just wanted to save money and didn't care how slow his boat would run.

HabanaJoe

It's the drives, they are stock Merc's I bet with 1.5:1 gears you are hard press to see 55 mph more like 50 mph because you can't get big props on those drives so the slip will be great since you won't spin them fast enough to be efficent.

Look at the gas version of any of your boats, say you spin the Yanmars at 3,500 rpm through 1.5, that is the same as your gas engines turning 3,500 rpm through 1.5 gears. Measure your slip at 3,500 at it will most likely be higher than at 4,400. If that is fact then you won't get the small props to work well because of lack of prop speed.

If that boat had Arneson's with closer to a 1:1 gear she would run allot better I bet into the low - mid 60's.

My 2 cents

boot

Hey buddy! Yeah, it depressing not having a boat so I try to stay away from here. That is untill a ride with "fogduckerIII" In his wicked Scarab had to wreck every practicle bone in my body!

boot

SUNK !?!?!?! They left that part out.......

boot

boot

Yeah, You thought it was slow with trips! With twins I'm not sure if it would outrun the tide!

Starflite X

'Power & Motor Yacht' tested one with triple Yanmar 350s and Blackhawk drives in July of 95. They reported 78 mph.

ELITE POWERBOATS

I would suspect high 40's low 50's depending on conditions.