looking at buying a set of used 502s to rebuild
#1
Registered
Thread Starter
looking at buying a set of used 502s to rebuild
OK, Who has a pair of good rebuildable 502s out there.
I am not a rich man either. Stupid me burnt up a 454 last weekend with seaweed in my strainer.
So I am looking into a differant Mill setup for a reasonable $.
I am a gearhead, so wrenching is not a problem. No rott please. If all else fails, I will rebuild the cooked engine for way less money. Long blocks only, no shorts.
I am not a rich man either. Stupid me burnt up a 454 last weekend with seaweed in my strainer.
So I am looking into a differant Mill setup for a reasonable $.
I am a gearhead, so wrenching is not a problem. No rott please. If all else fails, I will rebuild the cooked engine for way less money. Long blocks only, no shorts.
#3
Registered
iTrader: (2)
Join Date: Aug 2005
Location: Between A Womans Leggs in IL
Posts: 6,306
Likes: 0
Received 1 Like
on
1 Post
Fixx
theirs a few in the swap shop,dont know if they are still available tho?
http://www.offshoreonly.com/forums/s...-complete.html
http://www.offshoreonly.com/forums/s...h-low-hrs.html
http://www.offshoreonly.com/forums/s...-complete.html
http://www.offshoreonly.com/forums/s...h-low-hrs.html
#6
Registered
Join Date: Feb 2006
Location: NORTHERN ILLINOIS
Posts: 1,008
Likes: 0
Received 0 Likes
on
0 Posts
Be sure to check ebay, craigslist, etc. and then I have seen the best luck just making a few phone calls to the service shops around you that rebuild these motors or do general service work. Often they have the blocks sitting around and they don't do full rebuilds. Good luck.
#8
Registered
How much you want to spend?
I would call some of the engine builders, they probobly have some take outs that needs work.
Ateco, Cobra, Innovation, Potter.. a few.
Or give me a call. I have something in mind.
P
I would call some of the engine builders, they probobly have some take outs that needs work.
Ateco, Cobra, Innovation, Potter.. a few.
Or give me a call. I have something in mind.
P
#10
Registered
Thread Starter
kurt