Originally Posted by f_inscreenname
(Post 3478708)
That's why I buy junk cause i know it's junk from the start. Sorry for you pain.
|
brought the whole mess to the machine shop, none of it is any good besides the block, so i'm putting a list together to build a pair of 489s
|
Sorry to hear the bad news! :(
|
Sorry for your bad luck ,had it happen to me befor not with boat but car ,still hurts , but now you know the damage you can turn this round and know that when you are out playing in your boat it will be right .as you will know wot went in to building the motors , good luck regards paul from across the pond
|
Been there, done that. I'm 2 yrs and who knows how much $$ into restoring the piece of crap the broker in Chicago lied to me about.
Funny thing is, I tell all my friends I'm not that stupid :) Course they all just smile and nod. |
Originally Posted by SS930
(Post 3481278)
Sorry to hear the bad news! :(
|
It bites that you have to go through this, but I give you credit for attacking the problem so quickly. I've seen others in a situation like this who don't get on the fix right away due to $$ or just not motivated due to the disappointment\frustration.
Hope you get on the water with your good motors soon. That'll go a long way toward you forgetting this mess and enjoying your boat. |
thx for the support guys. the previous owner contacted me and says he knew nothing of any of the issues. w/e the case may be i just advise anyone to think real hard and inspect very well if buying "fresh" motors. If these motors really have 8 hours on them it was not put together in a very clean enviroment. Priced out complete rotating assemblies today, going .030 over on the blocks 6.385 i beam rods 4.25 stroke cast eagle cranks internal balance 9:1 compression forged pistons reusing the 781 oval port heads and weiand stealth intakes looking to make 480 - 500 hp and keep rpm at 5000 or less
|
Originally Posted by lil red
(Post 3481706)
thx for the support guys. the previous owner contacted me and says he knew nothing of any of the issues. w/e the case may be i just advise anyone to think real hard and inspect very well if buying "fresh" motors. If these motors really have 8 hours on them it was not put together in a very clean enviroment. Priced out complete rotating assemblies today, going .030 over on the blocks 6.385 i beam rods 4.25 stroke cast eagle cranks internal balance 9:1 compression forged pistons reusing the 781 oval port heads and weiand stealth intakes looking to make 480 - 500 hp and keep rpm at 5000 or less
|
Found a soft bulkhead today..... scheduling that in this weekend, so now my last saving grace of thinking I at least had a solid boat is gone. Its not real bad about 8"x10" on the bulkhead in frt of the motors behind the fuel tank
|
All times are GMT -5. The time now is 09:10 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.