Lower unit drain bolts?
I saw some lower unit drain bolts, that replace the standard screws, normally used by Mercury on bravo stye units and on my Sportmaster lowers. Who makes these?? I think they are either a bolt head or hex head design, will they fit on my sportmaster lowers on my 300XS? Thanks
|
Anxiously awaiting a reply to this too.. I stripped out that ridiculously cheap flathead screw. Haven't drilled it out yet because I was hoping for a replacement!
|
Originally Posted by waterboy222
(Post 3589382)
Anxiously awaiting a reply to this too.. I stripped out that ridiculously cheap flathead screw. Haven't drilled it out yet because I was hoping for a replacement!
|
Whats the best way to get one out that has the head stripped on it?
|
I think Imco has them.
Steve |
|
Originally Posted by waterboy222
(Post 3589401)
Whats the best way to get one out that has the head stripped on it?
|
Originally Posted by Knot 4 Me
(Post 3589423)
Take a small, sharp punch and a hammer to get it to turn. Berger's at LOTO showed us this trick this past spring.
|
Originally Posted by smiklos@sunprint
(Post 3589411)
I think Imco has them.
Steve |
Anybody know if these work on SSMIII and SSMIV?
At least Merc could have used hardened screw heads. |
All times are GMT -5. The time now is 12:44 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.