Tyson Garvin's 12 Rotor
#1
Tyson Garvin's 12 Rotor
Just saw this, not sure if it has been shared or not? Best of luck with the new Powerplant Truly badass !!!!!
http://www.12rotor.com/
http://www.autoweek.com/article/2014...WS01/140229886
http://www.youtube.com/channel/UCpQx...n66vO_A/videos
http://www.enginelabs.com/news/video...eady-for-dyno/
http://www.12rotor.com/
http://www.autoweek.com/article/2014...WS01/140229886
http://www.youtube.com/channel/UCpQx...n66vO_A/videos
http://www.enginelabs.com/news/video...eady-for-dyno/
#2
Registered
Here is a video of the engine on the dyno for the first test runs.
http://www.youtube.com/watch?v=Qcgg7w6TFQc&feature=share&list=UUpQxdg--kJ3GFNiXn66vO_A
http://www.youtube.com/watch?v=Qcgg7w6TFQc&feature=share&list=UUpQxdg--kJ3GFNiXn66vO_A
Last edited by BigSilverCat; 03-17-2014 at 12:24 PM.
#4
Registered
#6
Registered
I have a lot of time and money in this engine and I know it has not been in a boat yet, but at least we are thinking outside the box and trying to have a better option for you guys.
So far it has made 815 ftlbs at 3200 rpm. The porting we have should gain torque till around 5800 rpm.
[ATTACH=CONFIG]520420[/ATTACH]
#9
Registered
We're not sure yet, but the tip seals I'm using are in aircraft running the same hp load and they run 6800 rpm for hours straight, some of them have over 2000 hours. Most of the time someone would not be at 8500 rpm for long periods., (unless they are trying to set long distance endurance records).
Last edited by BigSilverCat; 03-17-2014 at 02:15 PM.