Hydro Hoist bunk question
#1
VIP Member
VIP Member
Thread Starter
Join Date: Aug 2010
Location: Stockton, CA
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
Hydro Hoist bunk question
I have a Hydro Hoist with 20ft 2x6 bunks. I have added a 4 foot 2x6 added to the rear that ends at the back step. The boat sits with 4 inches exposed off the rear to prevent hook.
My question is with another 40 inches of gap to the next step should I add a 1x6 to fill in the void?
My trailer has gaps in the same areas and with this just sitting I was hoping it would fine. for is it full support in front and back with just that air gap (pic below)
I usually get my information on searching OSO first as i am[ATTACH=CONFIG]543821[/ATTACH][ATTACH=CONFIG]543822[/ATTACH] sure this has been covered before.
My question is with another 40 inches of gap to the next step should I add a 1x6 to fill in the void?
My trailer has gaps in the same areas and with this just sitting I was hoping it would fine. for is it full support in front and back with just that air gap (pic below)
I usually get my information on searching OSO first as i am[ATTACH=CONFIG]543821[/ATTACH][ATTACH=CONFIG]543822[/ATTACH] sure this has been covered before.