New-Model Project Update: First 32 Phoenix In The Mold
#1
Correspondent
Correspondent
Thread Starter
New-Model Project Update: First 32 Phoenix In The Mold
The 32 Phoenix catamaran project moves another step closer to the finished product, http://speedonthewater.com/boat-rest...ix-in-the-mold
#5
Registered
.
The first hull is well under way...and it looks like the race deck is also in the works (see in the background)
Hope to see her compete at the SBI Worlds in Key West!
https://www.facebook.com/SmartMarineService/
Vacuum Resin Infusion:
The first hull is well under way...and it looks like the race deck is also in the works (see in the background)
Hope to see her compete at the SBI Worlds in Key West!
https://www.facebook.com/SmartMarineService/
Vacuum Resin Infusion:
Last edited by noli; 07-03-2016 at 09:25 PM.
#7
Registered
.
There's a builder that I know who is experimenting with center console catamaran configuration. Pics will be released in 2 weeks or less. Don't want to hijack this awesome thread but since you asked, the manufacturer is listed on my signature
.
There's a builder that I know who is experimenting with center console catamaran configuration. Pics will be released in 2 weeks or less. Don't want to hijack this awesome thread but since you asked, the manufacturer is listed on my signature
.
#8
Registered
Last edited by noli; 07-19-2016 at 04:19 AM.
#9
Registered
.
https://www.facebook.com/SmartMarineService/
not a single idle day at Smart Marine
main hull bulkheads are in place
looks like they're just weeks away from completing the deck mold ( see left side on a few pics )
building what looks to be the flared-deckmold-edges for the vacuum hoses, vacuum bag, double-sided tape, etc to rest on (typical on VRI molds)
https://www.facebook.com/SmartMarineService/
not a single idle day at Smart Marine
main hull bulkheads are in place
looks like they're just weeks away from completing the deck mold ( see left side on a few pics )
building what looks to be the flared-deckmold-edges for the vacuum hoses, vacuum bag, double-sided tape, etc to rest on (typical on VRI molds)
Last edited by noli; 07-20-2016 at 08:45 PM.