AmiableDave

My 2013 Formula Fastech came with Livorsi gages. With the boat still in warranty, one oil pressure gauge failed. All gauges read correctly.
After some years and gauges still reading properly, the faceplates and needles were faded and LED lights where out in another. I called Livorsi and they said they can replace the needles, face plates and LED's. I told him to completely look at all the gages for corrosion, etc, and if it costs more to repair it, to just replace the gauge with a new.
What I received back was disturbing. Four gauges had what looked


like plastic shavings underneath the new lens cover and on the face plates. One oil pressure gauge read 5 psi low and the GPS Speedo read 4 mph slower. I sent the gages back multiple times for repair and of debris under the new lens cover. They then tried to blamed me for the condition of the gages. Even though I sent them an email telling them to go through the gauges. If I had to do it over again. I would buy from a different manufacturer.

later

One last question what vendor out there to use for the gauges and shifter anyone have positive or negative results dealing with one vendor over another who to stay away from feed back would be great

33bajaoutlaw

Never had a failure in the boats I had equipped with Gaffrig gauges. They are a clean simple look and the monster version is very easy to read.

xlint89

Diamond Performance would be my first choice

Griff

Chances are most of your Gaffrig gauges were actually Livorsi aka Gaffrig Precision Instruments

Markus

For sure.

But didn't Autometer manufacture for both Livorsi (Gaffrig Precision Instruments) and Gaffrig Performance?

Thriller62

Gaffrig has new 2 inch white faced gauges that just came out and are made in the USA. This is my new panel I made for my mirage, still waiting on the fuel pressure gauges to be released.

Markus

That panel is a mix of Livorsi and Gaffrig Performance gauges.

Livorsi has not been allowed to sell Gaffrig-branded gauges for about 20 years…

Thriller62

The tachometers and speedometer are old I’m talking about the 2 inch gauges that say gaffrig performance.

PQ290Enticer

Looks great! I bought the same gauges except I didn't go with the bezels. I now wish I had. On another thread I asked about gauge orientation and you and I have them set up the same. A lot of guys will have only port gauges on the left and the starboard on the right side of the dash. I felt that you could get better info at a glance with them set up like ours. Nice job.