plasma arc
Probley not but does anyone have or know of a plasma arc/ cutter for sale or trade in NW IND/ILL area? Not a small one but to cut quarter to mabey half inch material. Thanks, Nick:crazy:
|
you will love it use one every day ours is a esab 875 cut 1in thick today it's rated at 3/4 doint like themaldinamic or thearmal arc esab or miller lincon
|
Try Mittler supply. They use to carry welding supplys and if they don't have it they can most likely steer you in the right direction. I just pulled up there website and it looks as if they have grown quite a bit from my days back in South Bend. Mittler Supply If you don't have any luck there you might want to look at www.weldingmart.com
Good luck |
make sur eyou get a 220 volt....some 110V claim to cut 1/2 " but forget about it...as said Esab , Miller , Lincoln in my opinion
|
I know where to get new ones but it sounds like you want a used one. Right? What power supply are you going to be using?
|
Wish you'd asked about a month ago.
My company just auctioned on off. It went real cheap. This one would've handled 1.5" material. |
thanks guys, ill look at that site, quiet... yes used, but open for sugestion, 220 single, but am willing to consider three phase, I know where to just walk in and leave w one, but was hoping to find a deal, you know how it goes, thanks again, nick
|
CHECH IN E-BAY , LAST TIME I LOKED THERE WHERE OVER 100 LISTED NEW/USED
|
All times are GMT -5. The time now is 03:38 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.