My motor went in last night and half rigged in the boat. :D :D I have no problems ... yet ..... :eek:
NEVER SAY YET!!!!!! :eek: |
Well for once I am top of things.. A first , I have to admitt. I finished my out drive a couple of weeks ago, was ready to go boating.. I pulle the truck to the Shell station for super Tuesday, save .06 a gallon on premium. Well the rear end in the truck couldnt take anymore.. better now than on a trip.. So I got the new rear end in the truck yesterday, finished up two outdrives and put a seal back on one of the trailer wheels, cause the new stuff didnt make it for the weekend.
So I am going for a ride this afternoon.. Just catching up on emails and such.. then off I go. I hope all works out for You Mike!! and everyone else that is behind.. Dick |
Well, the mill is in the boat. Not alligned, no exhaust, carb, or rigging done yet, but it's in the boat. The hard part is done. I am whipped!!!
|
Doing some glass and paint on mine..........hope to be on the water this weekend................might be Ho'in though.
|
If it's in, it's aligned. Remember the Team Chaos motto.
|
I fired #1 today and ran it in. Aside from a lot of steam from the port bank, probably from the cold tap water, so far, so good. Keeping fingers crossed. Now off to MO. and start on #2 next weekend.
|
I got mine out. Tooled around and came back in. It was so friggin rough out that I forgot to look at the gauges. The temps were around 180! I went back and there was very little water comming out. But there was some. After about 15 seconds of being off plane, water started flowing and the temps came down. When the boat is on plane I don't have enough water flow to cool the engine. I looked at the angles of the pickup and I suspect that when the drive is trimmed down that the low water pickup isn't getting the water directed into it. I'm gonna have to order a transom pickup and have it shipped to the condo for installation at loto. Oh, I can't wait! :rolleyes:
|
I had no problems today :D :D About 20 minutes ago dad and I woke up the neighborhood :D D: Nothing like the smell of burnt turbo blue 110 octane on a bueatiful night :cool:
Good luck foul |
It will be aligned monday night right after work.
|
Originally posted by Cord I got mine out. Tooled around and came back in. It was so friggin rough out that I forgot to look at the gauges. The temps were around 180! I went back and there was very little water comming out. But there was some. After about 15 seconds of being off plane, water started flowing and the temps came down. When the boat is on plane I don't have enough water flow to cool the engine. I looked at the angles of the pickup and I suspect that when the drive is trimmed down that the low water pickup isn't getting the water directed into it. I'm gonna have to order a transom pickup and have it shipped to the condo for installation at loto. Oh, I can't wait! :rolleyes: |
All times are GMT -5. The time now is 10:06 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.